createMiteredPipeSections MethodStatic

• Create section arcs for mitered pipe.
• At each end of each pipe, the pipe is cut by the plane that bisects the angle between successive pipe centerlines.
• The arc definitions are constructed so that lines between corresponding fractional positions on the arcs are axial lines on the pipes.
• This means that each arc definition axes (aka vector0 and vector90) are not perpendicular to each other.
• Circular or elliptical pipe cross sections can be specified by supplying either a radius, a pair of semi-axis lengths, or a full Arc3d.
  • For semi-axis length input, x corresponds to an ellipse local axis nominally situated parallel to the xy-plane.
  • The center of Arc3d input is translated to the centerline start point to act as initial cross section.

createMiteredPipeSections(centerline: IndexedXYZCollection, sectionData: number | Readonly<WritableXAndY> | Arc3d): Arc3d[]

Returns - Arc3d[]

Defined in

• curve/CurveFactory.ts Line 338